超外頻嘗試方向 - 電腦

要講得太多還是直接回一篇
我沒買APU.不過看到吃土雞就知道了
A10-7860k:3.6G---4.0G
Socket FM2+,support for PCIe 3.0
four CPU cores based on the Steamroller microarchitecture
eight Compute Units based on GCN 2nd gen microarchitecture
CPU:吃土雞架構 GPU:Sea Islands

最白話的講法:拉FSB/Bclk會動到HTT,NB,RAM,Igpu
以上皆可用除頻方式增減頻率.Igpu是怎樣除頻法我就不知道了
超頻就是先不動除頻.電壓硬幹先.這樣才會獲得最高效能
ram直接設1.65V以上好嗎.然後其他直接+0.1V拜託
想超頻就是要接受耗電爆炸.尤其是吃土雞核心的.超核爆
如果加壓都不行再來調除頻跟ram timing

你的是K版.所以可以直接拉倍頻.那htt,nb,ram ,igpu都不會連動
超不上去就是電壓硬幹了沒別招

再來如果你有注意看我po給你的網頁
RAM-Overclocking:
Like I have already mentioned the iGPU benefits significantly from
higher memory frequencies. 1866 MHz are usually no problem with
stock voltages – given that the memory kit is working at this speed.

I’m using a 2 x 2 GiB G.Skill Pi Kit with 2400 MHz on 1,65 Volt. The timings
are 9-11-9-28.However if I increase the memory speed to 2133 MHz or higher,
the sytem would not boot anymore and the post LED would show 51 which is a
memory issue according to the mainboard manual.so what do we do ?
My CPU requires to raise the NB-Voltage for 2133 MHz or higher.
I had to use 1,2875 Volt to get the system running.

Of course this depends on the CPU and you have to test step by step.

剛好作者也是拿Gigabyte的板子.你可以試試看.還有可以按Ctrl+F1看有啥隱藏選項







※ 編輯: pold123 (59.104.163.195), 04/09/2017 23:56:31
※ 編輯: pold123 (59.104.163.195), 04/10/2017 00:05:50